MRC MTX5000 - Page 132

Advanced Operations 5-8MTX5000 User and Technical Manual
3. Select the L/R option button for L (local mode), as
required.
Notes
If you are updating an existing analog Preset
configuration, select the Preset to be updated in
the following step.
If you are creating a new analog Preset
configuration, any analog Preset may be selected
in the following step.
4. Perform “Select Preset” on page 3-24 to select the
analog Preset required to be updated or to be used as
a “make-from”.
5. Select the Main screen PA operation button for PA
Off, as required.
6. Select the Main screen Setup option button and
observe the Setup screen is displayed. See Figure 5-
8.
Figure 5-8: Setup Screen
7. Select the User option button and observe the
Setup
User
Main
Radio
keyboard screen is displayed. See Figure 5-9.
Figure 5-9: Keyboard Screen
8. Enter your password, select the Enter key, and
observe the Operation Mode screen is displayed.
See Figure 5-10.
Figure 5-10: Operation Mode Screen
9. Select the FMT option button and observe the FMT
SETUP screen is displayed. See Figure 5-11 on
page 5-9.
! @ # $ % ^ & * ( ) _ +
Q W E R T Y U I O P { }
A S D F G H J K L :
Z X C V B N M < > ?
Shift BS
Clear CancelEnter
“
Operation Mode
Back
COFDM FMT ASI
IP
SCM
LMS-T
Save As Preset
DVBS
MPEG
Main