What to do if MRC PTX-PRO Transmitter shows no video?
If the PTX-PRO is unable to lock onto the video signal, first check for the correct operation mode. Then, check the cable connections to the SIGNAL INPUT and SDI/ASI INPUT connectors.
Why is the MRC PTX-PRO Transmitter power LED red?
A red power LED on the PTX-PRO indicates a Major Alarm. Turn off the power and call for service.
Why is the MRC PTX-PRO saying 'Not On Chnl'?
The 'Not On Chnl' message indicates that the channel frequencies defined in the Channel Plan for that band are not being recognized. Change the channel.
Why is the MRC PTX-PRO power LED amber?
An amber power LED on the PTX-PRO indicates a Minor Alarm. Check all Monitor Screens on the PTX-PRO display, and check the Error Code Screen on the PTX-PRO display.
How to fix MRC Transmitter when power LED is off?
If the power LED is off when the PWR switch is set to on ( I ), it means there is missing input power. Make sure the power cable is connected properly and verify the power source is turned on.
Warns about high RF power levels and potential health hazards from exposure.
Provides guidelines for safe RF exposure and working distances based on FCC recommendations.
Explains the calculation of Maximum Permissible Exposure (MPE) with relevant formulas.
Provides contact information for technical support and service inquiries.
Describes the controls, indicators, and connectors used on the PTX-PRO.
Details configuring the PTX-PRO using the front panel control switch.
Explains Power LED indications and on-screen display messages for status.
Details error codes, their status digits, and primary error identification.
Addresses general operational issues and specific problems with the Configurator software.
Guides on using the Configurator software for online and offline tasks.
General| Brand | MRC |
|---|---|
| Model | PTX-PRO |
| Category | Transmitter |
| Language | English |
To Next Page
