⚫ Installation:
The centrifuge should be installed on a flat, stable surface. Most customers
use a table or desk. When all four feet are touching the surface, connect the
power supply to the unit and then plug it in. Make sure the socket is grounded,
avoid an electric shock. (Most European electric sockets are grounded).
⚫ Operation:
1. Checking whether the round nut in the rotor is loose, if so, fasten them.
2. Prepare the tubes; put the test liquids into the tubes, checking whether
they are in the same level with your eyes.
3. Load tubes on the tube rack symmetrically; otherwise it will be resulted in
severe vibration in the process of centrifugal.
4. Close the lid, make sure it is locked
5. Set parameters
The time and speed will be showing on the panel, switches and buttons as the
following figure:
To Next Page
Loading...