OptiSwitch-100/100F
Standards Compliance
UL 1950; CSA 22.2 No 950; FCC Part 15 Class A; CE-89/336/EEC, 73/23/EEC
FCC Notice
WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
The user is cautioned that changes and modifications made to the equipment without approval of the manufacturer
could void the user’s authority to operate this equipment
It is suggested that the user use only shielded and grounded cables when appropriate to ensure compliance with
FCC Rules.
CE Mark
The CE mark symbolizes compliance with the EMC directive of the European Community. Such marking is
indicative that the specified equipment meets or exceeds the following technical standards:
• EN 55022 - Limits and Methods of Measurement of Radio Interference Characteristics of Information
Technology Equipment
• EN 50081-1- Electromagnetic compatibility - of Radio Interference Characteristics of Information
Technology Equipment Generic Emission standard Part 1 – Residential commercial and light industry
environment
• EN 50082-1 - Electromagnetic compatibility -- Generic immunity standard Part 1: Residential, commercial
and light industry environment
• EN61000-4-2 (previously IEC 1000-4-2) - Electromagnetic compatibility for industrial-process measurement
and control equipment Part 4: Section 2 - Electrostatic discharge requirements
• EN61000-4-3 (previously IEC 1000-4-3) - Electromagnetic compatibility for industrial-process measurement
and control equipment Part 4: Section 3 - Radiated electromagnetic field requirements
• EN61000-4-4 (previously IEC 1000-4-4) - Electromagnetic compatibility for industrial-process measurement
and control equipment Part 4: Section 4 - Electrical fast transient/burst requirements
• EN61000-4-5 - Electromagnetic compatibility for industrial-process measurement and control equipment
Part 4: Section 5 – Surge Immunity requirements
• EN61000-4-6 - Electromagnetic compatibility for industrial-process measurement and control equipment
Part 4: Section 6 – Immunity to conducted disturbances induces by radio frequency fields
• EN61000-4-8- Electromagnetic compatibility for industrial-process measurement and control equipment
Part 4: Section 8– Power frequency magnetic field immunity requirements
• EN61000-4-11 – Electromagnetic compatibility for industrial-process measurement and control equipment
Part 4: Section 11 – Voltage dips short interruptions and voltage variations immunity requirements
• EN61000-3-2 – Harmonic standard
• EN61000-3-3 – Voltage Fluctuation and Flicker standard
• CISPR 22 - Radiated and Line-conducted Class A
• EN 60950 - ITE Safety
A ‘Declaration of Conformity’, in accordance with the above standards, has been made and is on file at MRV.
This document and the information contained herein are proprietary to MRV and are furnished to the recipient
solely for use in operating, maintaining and repairing MRV equipment. The information within may not be utilized
for any purpose except as stated herein, and may not be disclosed to third parties without written permission from
MRV. MRV reserves the right to make changes to any technical specifications in order to improve reliability,
function or design.
©2001 MRV Inc.
i
To Next Page