MSH Protos 700x - Page 38

Instructions Manual
38
where I can nd the BIG PARTS where I can nd screws, ball bearings and u like that
box F bag C1+C2
Ball bearing
5x10x4
ART. MSH71081
ART. MSH71048
Washer
5x7,5x0,2
ART. MSH71048
Washer
7,5x9,8x0,2
ART. MSH71048
Hex screw M2,5x10
ART. MSH71103
ART. MSH71048
Tail blade holder
ART. MSH71048
ART. MSH71125
Thrust
5x10x4
ART. MSH51065
ART. MSH71048
Thrust bearing is marked “I” and
“O” for inside and outside
Hex screw M2x14
ART. MSH71105
ART. MSH71048
Hex screw M3x8
ART. MSH71109
Washer
3.1x8x1
ART. MSH71048
Tail pitch bushing
ART. MSH71048
Apply grease on thrust
bearing
Internal hole SMALLER
Internal hole BIGGER
VERY IMPORTANT
Do not overtighten.
Push hard the bearing
pack with a pin D=10mm
(the main spindle for
example)