1-3
Hardware Setup
† One CNR slot.
On-Board IDE
† Dual IDE controllers integrated in SiS
®
963/963L.
† Support Bus Master, Ultra DMA 66/100/133 operation modes.
† Can connect up to four IDE devices.
On-Board Peripherals
† On-Board Peripherals include:
- 1 floppy port supports 2 FDDs with 360K, 720K, 1.2M, 1.44M and 2.88
Mbytes.
- 1 serial port (COMA) and 1 VGA port
- 1 PS2 keyboard + PS2 mouse connectors
- 1 parallel port supports SPP/EPP/ECP mode
- 6 high speed USB 2.0/1.1 ports (Rear * 4 / Front * 2)
- 1 audio (Line-In/Line-Out/Mic-In) port
- 1 SPDIF-Out pinheader
- 1 RJ-45 LAN connector (Optional)
- 2 IEEE 1394 ports (Real * 1/ Front * 1 with pinheader) (Optional)
Audio
† AC97 link controller integrated in SiS
®
963/963L.
† 6 channels S/W audio codec Realtek ALC655 codec
- Compliance with AC97 2.2 Spec
- Meets PC2001 audio performance requirement
- Can support SPDIF out via a 3-pin SPDIF-Out pinheader.
LAN (Optional)
† Fast Ethernet integrated in SiS
®
963/963L.
† Realtek 8201B LAN PHY.
† IEEE 802.3 and 802.3x Standard Compatible
† Supports ACPI v1.0b and PCI power management v1.1 Standard
BIOS
† 2MB Award BIOS with PNP BIOS, ACPI, SMBIOS 2.3, Green and Boot Block.
† Provides DMI 2.0, WFM 2.0, WOL, WOR, chassis intrusion, and SMBus for
system management.
Dimension
† Micro-ATX Form Factor: 24.5 cm (L) x 23.5 cm (W).
Mounting
† 6 mounting holes.
To Next Page
Loading...
Need help?
General
