MSI 890FXA-GD70 series - Page 36

2-20
Hardware Setup
MS-7640
Chapter 2
Hardware Setup
MS-7640
Chapter 2
OC Dal Functon: OC GEAR & OC DRIVE
The button and the knob are used to adjust the FSB.
OC DRIVEOC GEAR
You can use them to change FSB clock at any tme under the operatng system. Ths
method does not need to nstall software or reboot. Please follow the steps below to
ncrease or decrease the FSB clock.
Press the OC Dal button to start adjustment. The OC Dal LED wll lght to ndcate
current operaton.
Turn the OC Dal knob clockwse/ant-clockwse to ncrease/decrease FSB clock.
You can set the value of OC Dal Step n BIOS.
Press the OC Dal button agan to complete adjustment. The OC Dal LED wll turn
o󰘯 automatcally.
Important
Before you use OC Dal functon to overclock the system. In order to ncrease the
success rate, you should set the voltage n BIOS properly.
After each of the adjustments, ths feature should be shut down. Otherwse, t would
a󰘯ect the system performance. Therefore, when you complete the adjustment, check
whether OC Dal LED s on or o󰘯, f OC Dal LED s stll lt, press the button and then
check agan.
1.
2.
3.
•
•