MSI 970A-G46 Series - Page 47

BIOS Setup
MS-7693
Chapter 2
2-7
BIOS Setup
MS-7693
Chapter 2
ACPI methods.
USB Con󰘰guraton
Press <Enter> to enter the sub-menu.
USB Controller
Ths tem allows you to enable/ dsable the ntegrated USB 2.0 controller.
Legacy USB Support
Enable or dsable support for USB keyboards, mce and 󰘱oppy drves. You wll be
able to use these devces wth operatng systems that do not support USB.
Onboard USB 3.0 Controller
Ths tem allows you to enable/ dsable the USB 3.0 controller.
Super IO Con󰘰guraton
Press <Enter> to enter the sub-menu.
Seral(COM) Port 0 Con󰘰guraton
Press <Enter> to enter the sub-menu.
Seral (COM) Port0
Ths tem allows you to enable/ dsable the seral port.
Seral (COM) Port0 Settngs
Select an address and correspondng nterrupt for the seral port.
Hardware Montor
Press <Enter> to enter the sub-menu.
CPU Smart Fan Target
Controls CPU fan speed automatcally dependng on the current temperature and
to keep t wth a spec󰘰c range. If the current CPU temperature reaches the target
value, the smart fan functon wll be actvated.
SYS Fan1 Control
Ths tem allows user to select how percentage of speed for the SYSFAN1.
Power Management Setup
Press <Enter> to enter the sub-menu.
EuP 2013
Energy Usng Products Lot 6 2013 (EUP) reduces power consumpton when system
s o󰘯 or n standby mode.
Note: When enabled, the system wll not support RTC wake up event functons.
Restore after AC Power Loss
Ths tem spec󰘰es whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power O󰘯] Always leaves the computer n the power o󰘯 state.
[Power On] Always leaves the computer n the power on state.
[Last State] Restore the system to the status before power falure or nterrupt
occurred.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶