MSI A88X-G41 PC Mate - Page 46

English
En-32
CPU Voltage/ CPU-NB Voltage [Auto]
Sets these voltages. If set to "Auto", BIOS will set these voltages automatically or you
can set it manually.
Spread Spectrum
This function reduces the EMI (Electromagnetic Interference) generated by modulating
clock generator pulses.
[Enabled] Enables the spread spectrum function to reduce the EMI (Electromag
-
netic Interference) problem.
[Disabled] Enhances the overclocking ability of CPU Base clock.
Important
If you do not have any EMI problem, leave the setting at [Disabled] for optimal
system stability and performance. But if you are plagued by EMI, select the value of
Spread Spectrum for EMI reduction.
The greater the Spread Spectrum value is, the greater the EMI is reduced, and
the system will become less stable. For the most suitable Spread Spectrum value,
please consult your local EMI regulation.
Remember to disable Spread Spectrum if you are overclocking because even a
slight jitter can introduce a temporary boost in clock speed which may just cause
your overclocked processor to lock up.
CPU Memory Changed Detect [Enabled]
Enables or disables the system to issue a warning message during boot when the CPU
or memory has been replaced.
[Enabled] The system will issue a warning message during boot and than needs to
load the default settings for new devices.
[Disabled] Disables this function and keeps the current BIOS settings.
OC Retry Count [1]
Resets counts for overclocking retrying. When overclocking has failed, setting this
item as [1, 2, 3] will allow system to reboot 1, 2, 3 times with the same overclocked
con󰘰guration. If overclocking has failed every time, the system will restore the defaults.
CPU Speci󰘰cations
Press <Enter> to enter the sub-menu. This sub-menu displays the information of in-
stalled CPU. You can also access this information menu at any time by pressing [F4].
Read only.
CPU Technology Support
Press <Enter> to enter the sub-menu. The sub-menu shows what the key features
does the installed CPU support. Read only.
MEMORY-Z
Press <Enter> to enter the sub-menu. This sub-menu displays all the settings and tim-
ings of installed memory.
▶
▶
•
•
•
▶
▶
▶
▶
▶