MSI H170A PC MATE - Page 41

41
BIOS Setup
▶Initiate Graphic Adapter [PEG]
Selects a graphics device as the primary boot device.
[IGD] Integrated Graphics Display.
[PEG] PCI-Express Graphics Device.
▶Integrated Graphics Share Memory [64M]
Selects a 󰘰xed amount of system memory allocated to the onboard graphics. This
item will appear when IGD Multi-Monitor is enabled.
▶IGD Multi-Monitor [Disabled]
Enables or disables the multi-screen output from integrated graphics and external
graphics card.
[Enabled] Enables multi-screen function for both integrated and external
graphics cards.
[Disabled] Disables this function.
▶USB Con󰄈guration
Sets the onboard USB controller and device function. Press <Enter> to enter the sub-
menu.
▶USB Controller [Enabled]
Enables or disables all USB controller.
▶XHCI Hand-off [Enabled]
Enables or disables XHCI hand-o󰘯 support for the operating system without XHCI
hand-o󰘯 feature. This item will appear when USB Controller is enabled.
▶Legacy USB Support [Enabled]
Sets Legacy USB function support.
[Auto] The system will automatically detect if any USB device is connected
and enables or disables the legacy USB support.
[Enabled] Enable the USB support for legacy operating systems that do not
support USB.
[Disabled] The USB devices are available only for UEFI applications.
▶Super IO Con󰄈guration
Sets system Super I/O chip parameters including LPT and COM ports. Press <Enter>
to enter the sub-menu.
▶Serial (COM) Port0 Configuration
Sets detailed con󰘰guration of serial(COM) port. Press <Enter> to enter the sub-
menu.
▶Serial (COM) Port0 [Enabled]
Enables or disables serial (COM) port.
▶Serial (COM) Port0 Settings [Auto]
Sets serial port (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.