2-21
Hardware Setup
2. After the hardware installation is completed, restart the system and install the NV
SLI driver/utility. A configuration panel will be provided for Multi-GPU control.
Check the Enable multi-GPU box to enable the SLI function for the onboard
graphics cards (concerning the details of multi-GPU settings, please refer to your
graphics card manual) .
3. Restart your system and a pop-up message will show in the system tray confirm-
ing the Multi-GPU has been enabled.
Check the box
Important
If you want to remove one graphics card and quit the SLI function, make sure
the "MultiGPU" function is disabled.
To Next Page
Loading...
Need help?
General
