14
Input Source
1st Level Menu 2nd Level Menu Description
HDMI™1 ∙ Users can adjust Input Source in any mode.
HDMI™2
DP
Auto Scan OFF ∙ Users can use the Navi Key to select Input Source at
below status:
• While “Auto Scan” is set to “OFF” with the monitor at
power saving mode;
• While “No Signal” message box is shown on the
monitor.
ON
PIP/PBP
1st Level Menu 2nd/3rd Level Menu Description
OFF ∙ PIP (Picture in Picture) allows users to
simultaneously display multiple video sources
on one screen. One program is displayed on the
full screen at the same time as one or more
other programs are displayed in inset windows.
∙ PBP (Picture by Picture) is a similar feature
that displays two input sources side-by-side on
the screen.
∙ Display Switch allows users to switch between
primary and secondary input sources.
∙ If there is only one signal input, the Display
Switch and Audio Switch will be grayed out.
∙ While Display Switch is selected in PBPx2, the
source will exchange clockwise.
∙ Activating PIP/PBP will affect:
Affected Function Function Status
» Response Time Unable to select
» MPRT
» Adaptive-Sync
Set to OFF
» HDMI™ CEC
Set to OFF & Unable to
select
» PIP: Screen Size 1:1
» PBP: Screen Size
4:3/ 16:9/ 21:9/ 1:1
Set to Auto & Unable
to select
PIP Source HDMI™1
HDMI™2
DP
PIP Size Small
Medium
Large
Location Left Top
Right Top
Left Bottom
Right Bottom
Display Switch
Audio Switch
PBP (X2) Source 1 HDMI™1
HDMI™2
DP
Source 2 HDMI™1
HDMI™2
DP
Display Switch
Audio Switch
To Next Page
Loading...
