54
BIOS Setup
▶ Legacy USB Support [Enabled]
Sets Legacy USB function support.
[Auto] The system will automatically detect if any USB device is connected
and enable the legacy USB support.
[Enabled] Enable the USB support under legacy mode.
[Disabled] The USB devices will be unavailable under legacy mode.
▶ Super IO Conguration
Sets system Super I/O chip parameters including COM port. Press Enter to enter the
sub-menu.
▶ Serial (COM) Port x Configuration
Enter to enter the sub-
menu.
▶ Serial (COM) Port x [Enabled]
Enables or disables serial (COM) port x.
▶ Serial (COM) Port x Settings [Auto]
Sets serial port x (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
▶ Power Management Setup
Sets system Power Management of ErP and AC Power Loss behaviors. Press Enter to
enter the sub-menu.
▶ ErP Ready [Disabled]
Enables or disables the system power consumption according to ErP regulation.
[Enabled] Optimize the system power consumption according to ErP
regulation. It will not support S4 & S5 wake up by USB, PCI and PCIe
devices.
[Disabled] Disables this function.
▶ Restore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power On] Boot up the system after restoring AC power.
before AC power loss.
▶ System Power Fault Protection [Disabled]
Enables or disables the system to boot up when detecting abnormal voltage input.
[Enabled] Protect the system from unexpected power operating and remain
the shut down status.
[Disabled] Disables this function.
▶ Windows OS Conguration
Enter to enter the sub-
menu.