CHAPTER 2 HARDWARE INSTALLATION
2-23
2.19 Power Saving LED Connector: JGL1
JGL1 can be connected with two-color LED. There are two types of LED
that you can use: 3-pin LED or 2-pin LED(ACPI request). When the 2-pin
LED is connected to JGL1, the light will turn green, when system is On.
During sleep mode, the 2-pin LED will change color from Green to Orange.
For 3-pin LED, when LED is connected to JGL1, this will light when the
system is On and blinks when it is in suspend/sleep mode. See page 3-19
(Power status LED) for further instruction.
3-pin LED 2-pin LED
1
3
1
3
Green Color
Orange
Color
1-3 Power LED 1-2 Dual Color
2-3 Suspend LED
JGL1
+
1
3
To Next Page
Loading...
