Chapter 3
3-10
CPU L2 Cache ECC Checking
This allows you to enable or disable the ECC (Error-Correcting Code) feature
for error detection and correction when data passes through L2 cache
memory. Settings are Enabled and Disabled.
Quick Power On Self Test
Setting the item to Enabled allows the system to shorten boot time since it
will skip some check items. Settings are Enabled and Disabled.
First/Second/Third Boot Device
The items allow you to set the sequence of boot devices where BIOS
attempts to load the disk operating system. The settings are:
HDD-0 The system will boot from the first HDD.
HDD-1 The system will boot from the second HDD.
HDD-2 The system will boot from the third HDD.
HDD-3 The system will boot from the fourth HDD.
Floppy The system will boot from floppy drive.
ZIP100 The system will boot from ATAPI ZIP drive.
LS-120 The system will boot from LS-120 drive.
SCSI The system will boot from the SCSI.
LAN The system will boot from the Network drive.
CD-ROM The system will boot from the CD-ROM.
Disabled Disable this sequence.
Boot Other Device
Setting the option to Enabled allows the system to try to boot from other
device if the system fails to boot from the 1st/2nd/3rd boot device.
Swap Floppy Drive
Setting to Enabled will swap floppy drives A: and B:.
Boot Up Floppy Seek
Setting to Enabled will make BIOS seek floppy drive A: before booting the
system. Setting options are Disabled and Enabled.
Boot Up NumLock Status
This item is to set the Num Lock status when the system is powered on.
To Next Page
Loading...
