3-13
BIOS Setup
Timing Setting Mode
The DRAM timing is controlled by the DRAM Timing Registers. The Timings
programmed into this register are dependent on the system design. Slower
rates may be required in certain system designs to support loose layouts or
slower memory. Setting options: Safe, Normal, Fast, Turbo, Ultra.
MA 1T/2T Select
This setting controls the SDRAM command rate. Setting to Auto allows the
the SDRAM command rate to be determined by the BIOS. Selecting MA 1T/MA
2T makes SDRAM signal controller run at 1T/2T rate. 1T is faster than 2T.
Setting options: Auto, MA 2T, MA 1T.
To Next Page
Loading...
