3-27
BIOS Setup
spikes of the pulses are reduced to flatter curves. If you do not have any EMI
problem, leave the setting at Disabled for optimal system stability and
performance. But if you are plagued by EMI, setting to Enabled for EMI
reduction. Remember to disable Spread Spectrum if you are overclocking because
even a slight jitter can introduce a temporary boost in clockspeed which may
just cause your overclocked processor to lock up.
Unused PCI Slot/DIMM Clk
This setting enables you to stop or activate the unused PCI slot & DIMM
clock. Setting options: Stop, Action.
DRAM Vcore Adjust (V)
Adjusting the DDR voltage can increase the DDR speed. Any changes made
to this setting may cause a stability issue, so changing the DDR voltage for
long-term purpose is NOT recommended.
To Next Page
Loading...
