MSI MS-7211 User Manual

i
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the measures listed below.
4 Reorient or relocate the receiving antenna.
4 Increase the separation between the equipment and receiver.
4 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4 Consult the dealer or an experienced radio/ television technician for help.
Notice 1
The changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Notice 2
Shielded interface cables and A.C. power cord, if any, must be used in order to comply with the emission
limits.
VOIR LA NOTICE D’NSTALLATION AVANT DE RACCORDER AU RESEAU.
Micro-Star International
MS-7211
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation
G52-M7211X3

MSI MS-7211 Specifications

General

Model	MSI MS-7211
Form Factor	Micro ATX
Socket	LGA 775
Memory Type	DDR2
Maximum Memory	4 GB
USB Ports	8 x USB 2.0
Expansion Slots	1 x PCIe x16, 2 x PCI
Storage Interface	4 x SATA, 1 x IDE

Summary

FCC-B Radio Frequency Interference Statement

Safety Instructions

Specifications

CPU

Details on supported Intel processors and their specifications.

Chipset

Information about the VIA P4M800CE and VT8237R Plus chipsets.

Main Memory

Specifications for supported DDR SDRAM memory modules.

Slots

Details on AGP and PCI slots available on the motherboard.

On-Board IDE

On-Board Peripherals

Hardware Setup

Central Processing Unit: CPU

Instructions for installing the CPU and CPU cooler.

LGA775 CPU and Cooler Installation (CPU Clip is optional)

Step-by-step guide for installing LGA775 CPU and its cooler.

Memory

Installing DDR Modules

Procedure for installing DDR DIMM memory modules.

Power Supply

ATX 24-Pin Power Connector: CONN1

Details on connecting the ATX 24-pin power supply connector.

ATX 12V Power Connector: JPW1

Information about the ATX 12V power connector for the CPU.

AGP (Accelerated Graphics Port) Slot

PCI (Peripheral Component Interconnect) Slots

BIOS Setup

Main Page

Overview of the main BIOS setup utility screen.

Standard CMOS Features

Basic system configurations like time and date.

Advanced BIOS Features

Advanced Chipset Features

Adjusting chipset registers for system performance.

Integrated Peripherals

Power Management Setup

PNP/PCI Configurations

H/W Monitor

Frequency/Voltage Control

Specifying settings for frequency and voltage control.

Load Optimized Defaults

Current FSB Clock

Displays current CPU FSB clock (Read-only).

Adjust CPU Ratio

Adjusting the CPU ratio for performance tuning.

Auto Detect DIMM/PCI Clock

Adjust CPU/AGP/PCI Frequency

Selecting CPU/AGP/PCI frequencies and overclocking.

Memory Voltage

AGP Voltage