MS-7250 Mainboard
3-24
FID/VID Change
Setting to Manual allows you to set the CPU ratio and voltage manually. Setting
options: [Auto], [Manaul].
Processor Frequency Multiplier
This item allows you to set the CPU ratio.
Processor Voltage
This item allows you to set the CPU voltage.
Memclock Mode
Select the DRAM frequency programming method. If set to “Auto”, the DRAM speed
will be based on SPDs. If set to “Limit”, the DRAM speed will not exceed the specified
value. If set to “Manual”, the DRAM speed specified will be programmed regardless of
SPD.
Adjust DDR Voltage
Adjusting the DDR voltage can increase the DDR speed. Any changes made to this
setting may cause a stability issue, so changing the DDR voltage for long-term
purpose is NOT recommended.
Memory Configuration
Press <Enter> to enter the sub-menu and the following screen appears.
Important
The settings shown in different color in CPU Voltage and DDR Voltage
help to verify if your setting is proper for your system.
Gray: Default setting.
Yellow:High performance setting.
Red: Not recommended setting and the system may be unstable.
Changing CPU Voltage and DDR Voltage may result in the instability of the
system; therefore, it is NOT recommended to change the default setting for
long-term usage.
To Next Page
Loading...
