MS-7250 Mainboard
3-20
Chassis Intrusion
The field enables or disables the feature of recording the chassis intrusion status
and issuing a warning message if the chassis is once opened. To clear the warning
message, set the field to [Reset]. The setting of the field will automatically return to
[Enabled] later.
CPUFAN Mode Setting
This field allows you to set the CPU fan mode. Settings are: [Disabled], [Thermal
Cruise], [Step Smart Fan].
CPU Step Smart Fan Low/ High Temp
When the CPUFAN Mode Setting set to the “Step Smart Fan”, this item will
apear. The mainboard provides another Smart Fan system which can control the
fan speed automatically depending on the current temperature to keep it within a
specific step. In these items you can set the low and high tempertures, and the
values between are the range of the steps.
CPU Fan Tolerance Value
When the CPUFAN Mode Setting set to the “Step Smart Fan”, this item will
apear. The Fan tolerance value will decide the intervals of the steps from low
temperature to high temperature. The fan speed will increase at higher steps
and decrease at lower steps according to the steps.
Current Smart Fan Step
This item shows how many steps between the low and high temperatures.
Read only.
H/W Monitor
To Next Page
Loading...
