English
28
DRAM Timing Mode [Auto]
Selects the memory timing mode.
[Auto] DRAM timings will be determined based on SPD (Serial Presence
Detect) of installed memory modules.
channel.
memory channel.
[Link] or [Unlink] in “DRAM Timing Mode”. User can set the memory timing for each
memory channel. The system may become unstable or unbootable after changing
memory timing. If it occurs, please clear the CMOS data and restore the default
settings. (Refer to the Clear CMOS jumper/ button section to clear the CMOS data,
and enter the BIOS to load the default settings.)
Memory Fast Boot [Auto]
Enables or disables the initiation and training for memory every booting.
when booting to accelerate the system booting time.
[Disabled] The memory will be initialed and trained every booting.
DRAM Voltage [Auto]
Sets the value for appointed voltage related to memory. If set to "Auto", BIOS will set
the voltage automatically or you can set it manually.
CPU Memory Changed Detect [Enabled]
Enables or disables the system to issue a warning message during boot when the
CPU or memory has been replaced.
[Enabled] The system will issue a warning message during boot and than
needs to load the default settings for new devices.
[Disabled] Disables this function and keeps the current BIOS settings.
installed CPU. You can also access this information menu at any time by pressing
[F4]. Read only.
CPU Technology Support
features does the installed CPU support. Read only.
MEMORY-Z
timings of installed memory. You can also access this information menu at any time
by pressing [F5].
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
