3-7
BIOS Setup
Device / Vender / Size
It will showing the device information that you connected to the SATA connector.
LBA/Large Mode
This allows you to enable or disable the LBA Mode. Setting to Auto enables LBA
mode if the device supports it and the devices is not already formatted with LBA
mode disabled.
DMA Mode
Select DMA Mode.
Hard Disk S.M.A.R.T.
This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis & Reporting
Technology) capability for the hard disks. S.M.A.R.T is a utility that monitors your
disk status to predict hard disk failure. This gives you an opportunity to move
data from a hard disk that is going to fail to a safe place before the hard disk
becomes offline.
Important
IDE Primary Master/Slave and Serial-ATA 1/2/3/4 are appearing when
you connect the HD devices to the IDE/ SATA connector on the mainboard.
Floppy A
This item allows you to set the type of floppy drives installed. Available options: [Not
installed], [360KB], [1.2MB], [720KB], [1.44MB], [2.88MB].
To Next Page
Loading...
