EasyManua.ls Logo

MSI P55-GD55 Series - Page 64

MSI P55-GD55 Series
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-22
BIOS Setup
MS-7589
BIOS Setup
MS-7589
“Advance DRAM Con󰘰guraton” sub-menu to be determned by BIOS based on the con-
󰘰guratons on the SPD. Selectng [Manual] allows users to con󰘰gure the DRAM tmngs
and the followng related “Advance DRAM Con󰘰guraton” sub-menu manually.
Advance DRAM Con󰘰guraton
Press <Enter> to enter the sub-menu.
CH1/ CH2 1T/2T Memory Tmng
Ths tem controls the SDRAM command rate. Select [1N] makes SDRAM sgnal
controller to run at 1N (N=clock cycles) rate. Selectng [2N] makes SDRAM sgnal
controller run at 2N rate.
CH1/ CH2 CAS Latency (CL)
Ths controls the CAS latency, whch determnes the tmng delay (n clock cycles)
before SDRAM starts a read command after recevng t.
CH1/ CH2 tRCD
When DRAM s refreshed, both rows and columns are addressed separately. Ths
setup tem allows you to determne the tmng of the transton from RAS (row ad
-
dress strobe) to CAS (column address strobe). The less the clock cycles, the faster
the DRAM performance.
CH1/ CH2 tRP
Ths settng controls the number of cycles for Row Address Strobe (RAS) to be
allowed to precharge. If nsu󰘲cent tme s allowed for the RAS to accumulate ts
charge before DRAM refresh, refresh may be ncomplete and DRAM may fal to
retan data. Ths tem apples only when synchronous DRAM s nstalled n the sys
-
tem.
CH1/ CH2 tRAS
Ths settng determnes the tme RAS takes to read from and wrte to memory cell.
CH1/ CH2 tRFC
Ths settng determnes the tme RFC takes to read from and wrte to a memory
cell.
CH1/ CH2 tWR
Mnmum tme nterval between end of wrte data burst and the start of a precharge
command. Allows sense ampl󰘰ers to restore data to cells.
CH1/ CH2 tWTR
Mnmum tme nterval between the end of wrte data burst and the start of a col
-
umn-read command. It allows I/O gatng to overdrve sense ampl󰘰ers before read
command starts.
CH1/ CH2 tRRD
Spec󰘰es the actve-to-actve delay of d󰘯erent banks.
CH1/ CH2 tRTP
Tme nterval between a read and a precharge command.
CH1/ CH2 tFAW
Ths tem s used to set the tFAW tmng.

Related product manuals