16
1st Level Menu 2nd/3rd Level Menu Description
Auto Config ∙ For D-Sub only, this setting will be grayed out
when detecting other input sources.
Clock
0-100
∙ Adjust Clock setting.
∙ For D-Sub only, this setting will be grayed out
when detecting other input sources.
Phase 0-100 ∙ Adjust Phase setting.
∙ For D-Sub only, this setting will be grayed out
when detecting other input sources.
H. Position 0-100 ∙ Adjust H.Position setting.
∙ For D-Sub only, this setting will be grayed out
when detecting other input sources.
V. Position 0-100 ∙ Adjust V.Position setting.
∙ For D-Sub only, this setting will be grayed out
when detecting other input sources.
Input Source
1st Level Menu 2nd Level Menu Description
HDMI™ ∙ Users can adjust Input Source in any mode.
D-Sub
Auto Scan OFF ∙ Users can use the Navi Key to select Input Source at
below status:
• While “Auto Scan” is set to “OFF” with the monitor at
power saving mode;
• While “No Signal” message box is shown on the
monitor.
ON
Navi Key
1st Level Menu 2nd Level Menu Description
Up
Down
Left
Right
OFF ∙ All Navi Key items can be adjusted via OSD Menus.
Brightness
Mode
Alarm Clock
Input Source
Refresh Rate
Info. On Screen
Audio Volume
To Next Page
Loading...
