Chapter 1
1-27 Getting Started
JUSB1~2: USB 3.0 Expansion Connectors
The USB 3.0 port is backwards compatible with USB 2.0 devices. It supports data
transfer rates up to 5Gbits/s (SuperSpeed).
BAT1
5
.
U
S
B
3
_
T
X
_
C
_
D
N
4
.
G
r
o
u
n
d
3
.
U
S
B
3
_
R
X
_
D
P
2
.
U
S
B
3
_
R
X
_
D
N
1
.
P
o
w
e
r
1
0
.
G
r
o
u
n
d
9
.
+
U
S
B
2
.
0
8
.
-
U
S
B
2
.
0
7
.
G
r
o
u
n
d
6
.
U
S
B
3
_
T
X
_
C
_
D
P
2
0
.
N
o
P
i
n
1
9
.
P
o
w
e
r
1
8
.
U
S
B
3
_
R
X
_
D
N
1
7
.
U
S
B
3
_
R
X
_
D
P
1
6
.
G
r
o
u
n
d
1
5
.
U
S
B
3
_
T
X
_
C
_
D
N
1
4
.
U
S
B
3
_
T
X
_
C
_
D
P
1
3
.
G
r
o
u
n
d
1
2
.
U
S
B
2
.
0
-
.
+
U
S
B
2
.
0
The JUSB1 (red mark) connector supports MSI’s new Super-Charger technology
which provides quicker USB charging of your smartphone or other USB-powered
devices. To enable this feature, please install the MSI Super-Charger application
on your computer. When the Super-Charger application is turned on, the JUSB1
connector will convert data channels to extra power channels to quickly charge your
connected device. Please note that when the Super-Charger application is turned on,
data transmission and synchronization over the JUSB1 connector will not function. To
enable the JUSB1 connector to function as a normal USB 3.0 connector, please turn
o the Super-Charger application. When the computer is in stand-by or hibernation
mode (S3/ S4/ S5) Super-Charger mode will automatically be enabled.
Important
•
Note that the VCC and GND pins must be connected correctly to avoid possible
damage.
•
Please only connect one device per USB port to ensure stable charging.
•
Super-Charger Technology is only available on select MSI motherboard models.
Please refer to the MSI website to check if your motherboard has Super-Charger
technology.
•
For iPad, JUSB1 (red mark) can still charge iPad in S3, S4, S5 state.
•
We recommend that don’t disconnect the device when you charge it in S1 state.
•
To use a USB 3.0 device, you must connect the device to a USB 3.0 port through
an optional USB 3.0 compliant cable.
To Next Page
Loading...
