Chapter 1
1-33 Getting Started
SLOW_1: Slow Mode Booting Switch
This switch is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
Normal
(Default)
Enabled
Important
Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
AUD_SW1: Audio Power Switch
This switch species the power mode for back panel audio ports.
Direct Power mode Onboard Power mode
(Default)
Important
Before switching to "Direct Power mode", please make sure the "Direct Audio
Power Connector” (AUDPWR1) has been connected to the power supply.
Do not use the audio power switch while the system is on because it will damage
the motherboard.
•
•
To Next Page
Loading...
