Quick Installation
Guide
For model:
UIS-322b
rev. 3a09
For the latest firmware updates,
please visit http://www.MSNswitch.com
Part 3: Software & Web Setup........................................................
For advanced user, MSNswitch can be customized for alternate usage
and configured for remote access.
To access the Web User Interface for customization;
1
2
Section 2
Step 1: While in the same LAN as the
device, open a browser and type
http://MSNswitch or run Netility (see
Part 5).
Step 2: A dialog box appears.
Username: admin
Password: (field is left blank)
Local user
Power
input Line
Power
input Line
LAN
LAN
LAN
WAN
WAN
Router / Hub
Electrical
Device
DSL modem
Remote user
WWW
Usage #3: MSNswitch setup to remote control electrical devices.
Software setup required (see Part 3).
Server
MSNswitch
NAS
IP Cam
Router / Hub
LAN
LAN
LAN
LAN
LAN
Power
input
Line
Power
input
Line
Power
input
Line
Usage #2: MSNswitch setup as watch-dog to keep internet device
alive. Software setup required (see Part 3).
Local user
MSNswitch
Power
input
Line
LAN
LAN
LAN
WAN
Power
input
Line
Router / Hub
xDSL / cable /
3.5G modem
Model:
UIS-322b
WWW
Usage #1: MSNswitch setup to perform automatic reset of router and
modem. No software setup required (see Part 1).
!
To Reset to Factory Default: Press UIS On/Off, Outlet 1 and Outlet 2 button for a few
minutes. All three LED light will blink, release buttons.
Green LED indicator
Blinking Internet is online
No internet connection
System is currently in protect mode
ON
OFF
Description
Outlet buttons,
long press
On/Off
(Default: On)
UIS ON/OFF
button
Detachable IEC socket
main power cord
LAN port
Internet
Green LED
indicator
USB charging
port 5V, 500mA
Fuse box (spare
10A fuse inside)
Part 2. Description ...........................................................................
Part 1. Hardware Setup....................................................................
Step 1: Connect the power
cord to device and wall outlet.
Step 2: Connect the router
power plug to an outlet.
Step 3: Connect LAN cable
from Router. The internet
LED will blink to show
internet is on-line.
Step 4: Press and hold (2
seconds) UIS On/Off button
to activate internet protection.
!
Press UIS on/off only when Internet LED is blinking. If Internet LED is OFF, pressing
button may result in unit performing outlet reset.
1 2
3 4
To Next Page
Need help?
General