Spa Tub and Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
1 32
pin holepin hole
15
Storage and Preparation for Future Use
1. Drain and clean the spa by following the “Drainage” and “Spa Cleaning” sections.
2. Reserve the set up instructions to deflate and disassemble the spa tub, spa
control unit and air bladder.
3. Make sure all the spa components and accesso- ries are thoroughly clean and
dry before storage. Air-dry the spa tub in the mild sun for an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent damage or
leakage to the spa liner.
5. Prepare new additional cartridge for next time use.
6. Store the spa and accessories in a dry, temperature-controlled environment,
between 0°C and 40°C (32°F - 104°F). We recommend storing the spa with
desiccant.
7. The original packaging is recommended for storage.
8. After long-term storage, fill the spa with clean water and sanitizer, and turn on the
FILTER for at least 1 hour before use.
DISPOSAL AND ENVIRONMENTAL PROTECTION
This marking indicates that the product should not be disposed of with other household waste. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle the product responsibly to promote the sustainable reuse of
material resources. Information on disposal can be obtained from your local authorities.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased for
environmentally safe recycling.
SUN
TROUBLESHOOTING
LED READING CAUSE SOLUTION
- - -
F0
F1
Contact the MSpa Service Center
Contact the MSpa Service Center
Change the water
Contact the MSpa Service Center
Clean the parts and tubes that the water goes through
1. Add more water to the minimum line
2. Clean the parts and tubes that water goes through
3. Contact the MSpa Service Center
ERROR CODE CHART
Signal wire is loose
Communication failed
Water temperature is below 0°C (32°F) or exceeds 50°C (122°F)
Temperature sensor failure
F1 immediately shows after pressing FILTER , HEATING or UVC
F1 shows 15s after pressing FILTER, HEATING or UVC
®
To Next Page
Loading...
Need help?
General
