3.3.1 Switching the device on/off.
Once the device is connected to the power source, press and hold
the "POWER" button for 3 seconds - the display will show the
current temperature inside the refrigerator.
Press and hold the "POWER" button for 5 seconds to switch off the
device.
3.3.2 Setting the temperature
After switching the device on, press the "UP" button (up arrow icon)
or "DOWN" (down arrow icon) depending on the temperature you
wish to set and the change of settings will be continuously indicated
on the digital display. After that the screen will return to the display
of the current temperature inside the fridge
3.3.3 Standby mode (SLEEP)
To activate the standby mode, press and hold the button labelled
"SLEEP" (moon icon) for 1 second after switching the device on. In
standby mode the unit operates in an energy-saving manner, i.e.
compressor speed is reduced, the unit consumes less power and the
display shows an indicator light signalling that the mode has been
activated.
3.3.4 Device settings
To change the operating settings of the device, press and hold the
"SLEEP" button (moon icon) for 5 seconds while the device is
switched on:
a) Selection of voltage protection
When displaying H1/H2/H3 values while 2 Hz is blinking, select
the value (the default is H2). In order to change a parameter,
press the "DOWN" or "UP" button to select a given value. If no
button is pressed for the next 5 seconds, the device will save
the currently selected value.
Input voltage Level Cut-off level (V)
12V
recognition
To Next Page
Loading...
Need help?
General
