N - Direction of rotation of the milling cutter
P - Workpiece
O - Direction of feed
3.3. Cleaning and maintenance
a) Use only non-corrosive cleaning agents for cleaning the surfaces.
b) After each cleaning, all the parts should be dried well before the unit is used
again.
c) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d) Perform regular inspections of the unit checking technical fitness and any
damages.
e) Use a soft cloth for cleaning.
f) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
unit is made.
Parts list:
To Next Page
Loading...