How to fix rough idling MTD 13AJ795S059 engine?
A rough idling MTD Lawn Mower engine can be caused by: * A fouled or faulty spark plug, or a gap that is too wide: replace the spark plug and set the plug gap. * A dirty air cleaner: replace the air cleaner element and/or clean the pre-cleaner, if equipped.
Why MTD Lawn Mower engine runs erratic?
An MTD Lawn Mower engine may run erratically due to several reasons: * The unit might be running with the CHOKE activated: move the throttle control out of the CHOKE position. * Spark plug wires might be loose: connect and tighten the spark plug wire. * The fuel line might be blocked, or the fuel might be stale: clean the fuel line and fill the tank with clean, fresh gasoline; replace the fuel filter if equipped. * The vent in the gas cap might be plugged: clear the vent or replace the cap if damaged. * There might be water or dirt in the fuel system: drain the fuel tank and refill with clean, fresh gasoline. * The air cleaner might be dirty: replace the air cleaner paper element or clean the foam precleaner, if equipped.
What to do if MTD 13AJ795S059 Lawn Mower will not mulch grass?
If your MTD lawn mower won't mulch grass, consider the following: * The engine speed might be too low: place the throttle in the FAST (rabbit) position. * The grass might be wet: do not mulch when the grass is wet. * The grass might be excessively high: mow once at a high cutting height, then mow again at the desired height or make a narrower cutting swath. * The blade might be dull: sharpen or replace the blade.
Why MTD 13AJ795S059 engine overheats?
Your MTD Lawn Mower engine may overheat due to: * Low engine oil level: fill the crankcase with the proper amount and weight of oil. * Restricted airflow: clean grass clippings and debris from around the engine’s cooling fins and blower housing.
What causes excessive vibration in MTD Lawn Mower?
Excessive vibration in your MTD Lawn Mower can be caused by: * A loose or unbalanced cutting blade: tighten the blade and spindle, and balance the blade. * A damaged or bent cutting blade: replace the blade.
Why MTD Lawn Mower makes uneven cut?
An uneven cut with your MTD Lawn Mower can be due to: * The deck not being leveled properly: perform a side-to-side deck adjustment. * A dull blade: sharpen or replace the blade. * Uneven tire pressure: check the tire pressure in all four tires.
What to do if MTD Lawn Mower engine hesitates at high RPM?
If your MTD Lawn Mower engine hesitates at high RPM, it might be because the spark plug gap is too close. Remove the spark plug and reset the gap.
Why MTD Lawn Mower engine fails to start?
Your MTD Lawn Mower engine may fail to start due to several reasons: * The PTO/Blade might be engaged: place the knob (or lever) in the disengaged (OFF) position. * The spark plug wire might be disconnected: connect the wire to the spark plug. * The fuel tank might be empty or contain stale fuel: fill the tank with clean, fresh (less than 30 days old) gas. * The choke might not be activated: place the throttle control in the CHOKE position. * The spark plug might be faulty: clean, adjust the gap, or replace the plug. * The fuel line might be blocked: clean the fuel line and replace the fuel filter. * The engine might be flooded: crank the engine with the throttle in the FAST position. * The parking brake might not be engaged: engage the parking brake. * The throttle con...
General| Cutting Width | 46 in |
|---|---|
| Start Type | Electric |
| Weight | 520 lb |
| Engine | Briggs & Stratton Intek |
| Engine Brand | Briggs & Stratton |
| Number of Blades | 2 |
| Transmission Type | Hydrostatic |
| Deck Material | Steel |
| Drive System | Rear Wheel Drive |
| Cutting Height Adjustment | Lever |
| Cutting Height | 1.25 - 3.75 inches |
| Wheel Size | 15 inches front, 20 inches rear |
To Next Page
