10 Section 4 — ASSembly & inStAllAtion
Assembling and Installing the Weight Bar
Assemble, then attach the weight bar to the front steering
assembly using the hardware in pack 683-05147, as shown in
Figure 4-8 and Figure 4-10.
1. Install the counter weight mounting bracket to the counter
weight using two 710-0572 carriage bolts, two 736-0159
flat washers and two 712-04063 flange lock nuts from
hardware pack 683-05147. See Figure 4-8.
Figure 4-8
2. If present, remove the bumper from the tractor.
Note: Some tractors come equipped with a bumper
installed. The bumper may be retained for later use in case
in which the bagger is removed.
Figure 4-9
3. Secure the weight bar assembly to the tractor using two
710-0378 hex bolts, two 736-0159 flat washers and two
712-04063 flange lock nuts from hardware pack 683-05147.
Note: Use the top holes on the tractor frame.
Figure 4-10
To Next Page
Loading...
