MTD 50 - Page 17

17
Series 050
Ref.
No.
Part No. Part Description
1. 747-1161A Blade Control Handle
2. 749-1092A Upper Handle
3. 720-0279 Wing Nut
4. 710-1205 Eye Bolt
5. 710-1174 Carriage Bolt 5/16-18 x 2.0
6. 720-0284 Wing Nut
7. 736-0451 Shoulder Washer.320 ID x.93 OD
8. 749-04037 Lower Handle
9. 725-0157 Cable Tie
10. 710-0599 TT Screw 1/4-20 x 0.5”
11. 17098 Hinge Clip
12. 731-04019 Trail Shield
13. 682-3063A Handle Bracket Assembly LH
14. 682-3062A Handle Bracket Assembly RH
15. 787-01097 22” Deck Assembly
16. 710-0654A TT Screw 3/8-16 x 1.0
17. 741-0717 Thrust Bearing
18. 720-0426 Height Adjuster Knob
19. 687-02052 Lever Assembly (includes Ref. #18)
20. 710-0216 Hex Cap Screw 3/8-16 x.75
21. 738-1127 Shoulder Screw
22. 736-0741 Bell Washer.760 ID x 1.25 OD
23. 687-02080 Rear Pivot Arm Assembly - RH
687-02079 Rear Pivot Arm Assembly - LH
24. 734-04082 Rear Wheel 12 x 1.8
27. 736-0270 Bell Washer.265 ID x.75 OD
28. 738-1172 Shoulder Screw
29. 734-1988 Front Wheel 7 x 1.8
30. 748-0376C Blade Adapter
31. 742-0642A Standard Blade 22”
32. 736-0524A Blade Bell Support
33. 710-1044 Hex Cap Screw 3/8-24 x 1.5
34. 747-0710 Hinge Pin
35. 732-1014 Torsion Spring
36. 17032A Deflector Chute Adapter
37. 731-1034B Hinged Chute Deflector (Includes 34,
35, & 36)
39. 746-0957 Blade Control Cable - 37.25” Lg.
44. 712-0431 Lock Nut 3/8-16
45. 741-0751 Height Adjuster Bearing
46. 687-02051 Lever Assembly (includes Ref. # 18)
47. 687-02094 Pivot Arm
Ref.
No.
Part No. Part Description