Self-propelled Chipper Shredder Vacuum
8
3.19. Pivot transmission rearward while sliding it to the
right. See Figure 3.19.
3.20. Once the left side comes out, slide the transmis-
sion to the left. At this point the transmission will
be solely in your hands
3.21. Install new transmission in opposite order that
was taken out.
4. IMPELLER AND BELT REMOVAL
4.1. Disconnect the H.T. lead from the spark plug.
4.2. Remove the transmission as described in the
TRASMISSION REMOVAL section of this man-
ual.
4.3. Safely tilt and support the front of unit to provide
access to the front wheel and nozzle mounting
hardware.
4.4. Remove the hub caps.
4.5. Remove front wheels using an 1/2 wrench.
4.6. Using a 15/16” wrench and a 9/16” wrench
remove height adjusters and cross bar.
See Figure 4.6.
NOTE: The front cross bar is longer than the
rear cross bar
Figure 3.19
Self propelled transmission
Figure 4.6
Height adjuster
Cross bar
To Next Page
Loading...