Adjusting the front wheel toe-in (trac-
tors with the HPS)
Having changed front wheel track width,
adjust the toe-in by altering steering rod
length.
1. Inflate the tyres to the required pres-
sure.
2. Drive the tractor forward on the flat
ground to the distance of at least 3 m
and stop it. Apply the parking brake.
3. Measure the distance “B” between two
opposite points on the rim edge, be-
hind FDA at the wheel axis height.
4. Drive the tractor forward so that the
front wheels would turn by 180 and
measure the distance “A” in front of
FDA between the same points as
when measuring the distance “В”. The
toe-in is set correctly when the value
“A” is less than “B” by 0...8 mm. If toe-
in does not correspond to these val-
ues, proceed as follows:
5. Release the nuts (1) of the steering
rod adjustment tube (2).
6. Rotating the tube, set the required
toe-in value.
7. Tighten the nuts (1).
FDA with bevel reducing gears
Front axle
FDA with planetary cylindrical reducing
gears
To Next Page
Loading...
