Operation of the tractor equipped
with a power governor
When the depth obtained during the tillage
with the power control handle put to the
maximum depth is insufficient, reposition
the central rod (1) of the hitch to the mid-
dle hole of shackle (2).
When operating using the power control
for both tillage and cultivation, adjust the
correction rate handwheel (1). Rotating
the handwheel clockwise reduces the cor-
rection rate and rotating the same coun-
ter-clockwise increases the rate.
The handwheel should be adjusted on
completion of the plough (cultivator) ad-
justment; when doing this, achieve the
smooth automatic depth control during the
operation by rotating the handwheel.
Do not rotate the handwheel clockwise to
the stop since it will result in too slow lift-
ing of the agricultural machine and cause
higher skidding of the tractor’s driving
wheels.
Adjust the correction rate handwheel and se-
lect the holes in the shackle when installing
the central rod for particular soil conditions
and each type of agricultural machines. No
r e -adjustments in the operation are required.
To Next Page
Loading...
