Controls and Instrumentation
Shuttle-gear control
(if installed)
The shuttle gear is controlled with lever (2) having
the following positions:
• ON – rearmost position;
• OFF (forward motion) – foremost position.
ATTENTION! When putting the gearbox
lever to position “R” (reverse motion),
the lever being in rearmost position, the
tractor will move forward.
Speed reducer control
(if installed)
The change-gear lever of the speed reducer (1) has
five positions:
• “OFF”;
• “ON”;
• “N” – neutral;
• “1” – first gear of the speed reducer;
• “2” – second gear of the speed reducer.
The rod for switching over the speed reducer ranges
(2) has three positions:
• I – first range corresponding to reduced
speeds (lower position);
• II – second range corresponding to increased
speeds (upper position);
• N – neutral (mid position) .
To Next Page
Loading...
