Müba KAL 275 User Manual

18.08.2014
Structure and use guidance
The
MM
lifting jack serves for lifting or lowering components
and loads with assembly works on building sites. Only vertical
loads (in the plumb line) must be carried.
With the lifting jack e.g. steel girders or wood purlins can be millimeter-exactly
aligned. The weight is turned up or down by means of crank within selflocking
spindle transmission. The lifting jack is equipped with swivel rollers, so that it
can be easily moved to the load bearing position when not carrying a load.
When loaded, it must (only) be moved in longitudinal direction, which enables
precise alignment of components.
General note
Only components in perfect status and original equipment may be used.
This must be checked before use. The lifting jack must not be used until
it has been repaired appropriately.
The lifting jack is to be used only according to the intended purpose.
Any other improper use is prohibited.
The rules for the prevention of accidents are to be observed.
Technical data
lifting height....................................1.10 - 2.75 m
with adapter ..................................1.36 - 3.00 m
light mass heading fork ..........36 x 21 x 11.5 cm
dimensions folded ..............1.59 x 0.81 x 0.60 m
load-bearing capacity ..............................600 kg
(In case of paired operation 2 x 450 kg = 900 kg)
weight ........................................................86 kg
crank, adjustable...... ..............Order no. 12361
adapter ....................................Order no. 12374
Lifting jack
Typ: KAL 275
Order no. 12373
B
E
R
U
F
S
G
E
N
O
S
S
E
N
S
C
H
A
F
T
geprüfte
Sicherheit
A-BAU
02054
heading fork
load loop
load arm
spindle
spindle transmission
stand
props
crank
underframe
adapter
height 1.10 m - 2.75 m
height 1.36 m - 3.00 m

Müba KAL 275 Specifications

General

Brand	Müba
Model	KAL 275
Category	Jacks
Language	English

Summary

Structure and Use Guidance

General Note

General notes on component status, repair, intended use, and safety rules.

Technical Data

Details lifting height, load capacity, dimensions, weight, and order numbers.

Building Up the Lifting Jack

Caution, Risk of Crushing

Warns about increased risk of crushing fingers and hands during erection and dismantling.

Use and Operation

Caution, Risk of Crushing

Warns about increased risk of crushing during operation.

Lifting a Load Off the Ground

Using One Lifting Jack

Details lifting a load using a single lifting jack, focusing on center of gravity.

Using Two Lifting Jacks

Before Each Employment is to be Considered

Storing the Lifting Jacks

Instructions on stacking and storing multiple lifting jacks safely.