- Never operate this product if it has a damaged power cord, if it is not work-
ing properly, after it has been dropped or damaged, or dropped into water
while plugged in. For assistance, contact Mueller support.
- Do not disconnect the power adapter from the power socket by pulling on
the power cord- this could damage the power adapter or the power socket.
Disconnect the power adapter from the power socket by pulling on the plug.
-Make sure that the power cord does not hang over the edge of a table and
that it is not touching a heated surface.
-The Hair clipper must be used only with the original power adapter that
came with it. To avoid a dangerous situation from arising, never use a differ-
ent power adapter.
-Never use the power adapter supplied with this Hair clipper for any other
purposes.
-Keep the power adapter and its power cord dry.
-Do not wind the power cord of the power adapter around the handle of the
Hair clipper.
-Do not connect and disconnect the power adapter cord to and from the
power socket with wet hands.
- Do not charge the shaver when the temperature is below 0°C (32°F) or
above 40°C (104°F).
-Do not charge the Hair clipper for longer than is necessary for it to charge
fully. Once it is charged, disconnect it from the power socket.
- Never put the product or the power cord in direct sunlight or store at a
temperature above 140°F (60°C).
-The Hair clipper is equipped with a built-in long-life battery that can only be
removed from the Hair clipper at a professional service center. Never
attempt to remove it from the Hair clipper yourself.
-Do not place the Hair clipper and its accessories near heaters, open fires,
or other sources of heat.
IMPORTANT
This shaver has a built-in rechargeable battery. Do not throw it into the
fire, apply heat, charge, use, or leave in a high-temperature environment.
To Next Page
Loading...