① Current tra
nsducer (Jaw)
② Jaw opening lever
③ Power switch : Press this switch for power ON or OFF. The meter is set to
power off mode at approximately 10 minutes after the power
switch on. However, in max. hold and min. the auto power off
mode is cancelled.
④ DCA selector switch : Press this switch to select DCA measurements.
⑤ ACA selector switch : Press this switch to select ACA measurements.
⑥ RANGE UP switch : Press this switch to select the range up.
⑦ RANGE DOWN switch : Press this switch to select the range down.
⑧ ZERO ADJ switch : In DCA measurement, this switch is used for zero
adjustment. In ACA measurement, when this switch is
pressed, the input applied at that time is stored as zero
reference point. Subsequent readings display deviations
from this reference point. To release, press DCA/ACA
selector switch or RANGE UP/DOWN switch.
⑨ DATA HOLD switch : This switch locks the display. When pressed. “DH” mark
is displayed. To release, press the switch again to release
the hold condition.
⑩ MAX HOLD switch : Press this switch to select the maximum value
measurement. When pressed, “MAX-H” mark is
displayed. To release, press the switch again.
⑪ MIN HOLD switch : Press this switch to select the minimum value
measurement. When pressed, “MIN-H” mark is
displayed. To release, press the switch again.
⑫ LCD display
⑬ Battery cover
⑭ Wrist strap
‐4‐
To Next Page
Loading...
Need help?
General
