Multicalor Udara Udara 10 - Safety; Warnings and Symbols; Improper Use; General Safety Instructions

4
IHL_UDARA_2023_BEGB
This section must be carefully studied by the installer
and the user.
1.1 Warnings and symbols
A number of symbols point out possible dangers that
may occur when installing or using the appliance.
Depending on the seriousness of the potential
situation, other symbols, icons or words are used.
Always take these warnings seriously and never ignore
them.
1.2 Improper use
The Udara air heater is intended for heating systems
based on hot air where both the heated and the intake
air is distributed through a system of ducts.
Iftheapplianceisusedinexpertlyorimproperly,a
situation may be created that entails danger for the
user or third parties or can lead to damage to the
appliance or the environment.
You may only install the Udara if you combine the
appliance with the accessories listed in the manual for
thecombustionairsupply(CAS)anduegasoutlet
(FGO).
As an installer or user you have the obligation to
closely follow the instructions contained in the manual
of the appliance or the possible accessories. You
must, moreover, respect all inspection and
maintenance conditions
You must connect the appliance electrically in
accordancewiththeprotectiondegreespeciedon
the nameplate and in accordance with the locally
applicable regulations.
If you implement changes to the appliance that are
not described in the manual, you must ask for written
permission from the manufacturer.
Transgressions to these instructions will be deemed
not according to the regulations and may lead to
dangerous situations or material damage regarding
which the manufacturer rejects any responsibility.
1.3 General safety instructions
The installation, mounting, disassembly,
commissioning, maintenance and repair must only be
performed by professionals. They must have all legal
qualicationsand,bypreference,theymusthave
followed training at the manufacturer of the appliance.
As a user, you must closely follow the maintenance
instructions. Ask your installer to go through this
section if you have any questions.
1.3.1 Danger of fatal injury because of gas leaks
With regard to gas smells in buildings:
• extinguishallnakedames(suchasfrom 
smoking,cookers,etc.).
• Do not operate any doorbells, switches, plugs,
telephones, entry panels or other devices
• Close the main gas valve and the gas valve on the
product.
• Open windows and doors.
• Evacuate the building and stop third parties from
entering the building.
• Warntherebrigadeusingatelephone 
connectionoutsidethebuilding(forexample,at
theneighbours).
• If the leak occurs in front of the gas meter, warn
the energy company.
Liquid gas is heavier than air and will collect near the
oor.Iftheapplianceisbeinginstalledbelowground
level, leaking liquid gas will collect and, therefore,
therewillbeanexplosionrisk.
• Ensure that liquid gas can never escape from the
appliance or the gas pipe.
1.3.2 Dangeroffatalinjurybecauseofammable
substances
Donotuseorkeepexplosiveorammablesubstances
(petrol,thinner,paper,etc.)neartheappliance.
1.3.3 Danger of fatal injury because of
combustiongasesescaping
Ifuegasesescape,thiscanleadtodangerous
situations.
• Only use the appliance with a fully installed
CAS/FGO
1 Safety
Danger!
This symbol warns you about a serious danger.
Intervene immediately to prevent heavy physical or
fatal injury or signicant material damage.
Danger!
This symbol warns about a danger or fatal injury
because of an electric shock. Ignoring this warning
can lead to signicant physical or fatal injury.
Warning!
This symbol warns about a dangerous situation.
Ignoring this warning can lead to physical injury,
material damage or environmental damage.
Attention!
This symbol warns about a situation that deserves
your attention. Ignoring this warning can lead to
material damage. .
Information(s)
This symbol indicates that somewhere else in the
manual you can nd more information about this
topic or it will refer you to a local standard.