114
www.multilaser.com.br
Figure 1-2 Rear Panel sketch
1.4.2 The Rear Panel
The following parts are located on the rear panel (View from left to right).
• POWER: The Power socket is where you will connect the power adapter. Please use the power adapter provided with this
RE027 150Mbps Wireless N Router.
• 1,2,3,4 (LAN): These ports (1, 2, 3, 4) connect the Router to the local PC(s).
• WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet.
• RESET
There are two ways to reset to the Router’s factory defaults:
1) Use the Factory Defaults function on “System Tools > Factory Defaults” page in the Router’s Web-based Utility.
2 Use the Factory Default Reset button: With the Router powered on, use a pin to press and hold the Reset button
(about 5 seconds) until the SYS LED becomes quick-flash from slow-flash. And then release the button and wait the
Router to reboot to its factory default settings.
• WIRELESS ANTENNA: To receive and transmit the wireless data.
To Next Page
Loading...