134
www.multilaser.com.br
Figure 4-5 the Network menu
4.5 Network
There are three submenus under the Network menu (shown in Figure 4-5): LAN, WAN and MAC Clone. Click any of them, and you will
be able to configure the corresponding function.
4.5.1 LAN
Choose menu “Network > LAN”, you can configure the IP parameters of the LAN on the screen as below.
• MAC Address - The physical address of the Router, as seen from the LAN. The value can’t be changed.
• IP Address - Enter the IP address of your Router or reset it in dotted-decimal notation (factory default: 192.168.1.1).
• Subnet Mask - An address code that determines the size of the network. Normally use 255.255.255.0 as the subnet
mask.
Notes:
a. If you change the IP Address of LAN, you must use the new IP Address to log in the Router.
b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the DHCP server will change accordingly at
the same time，while the Virtual Server and DMZ Host will not take effect until they are re-configured.
Figura 4-6 LAN
To Next Page
Loading...