Profi – Mixers
3 - Servoside Mixers
In the mixer definition menu (ABC1) a new mixer called Wheel+ was created,
which was assigned to the nose leg servo channel in the servo assignment
menu (JKL4), an input from the rudder was added to use curve 1
Apart from the standard curves the Profi gives you the option to create
a bespoke curve if you require, here’s one made up to mix rudder
control into nose wheel steering
In the mixer menu (GHI3) opening the Wheel+ mixer and rudder input
opens the seven point curve, scrolling down to each position P1 thru P7
allows you to specify the mix input at each position.
To Next Page
Loading...
