Profi – Mixers
3 - Servoside Mixers
Although Flaps and Elevator inputs
are available, no input has been
specified so these controls have no
effect on the AILERON+ output
Spoiler input is set at 40% and is active in
Flightphase 3, note no offset required as servo
centre point is with the ailerons at neutral position
on this model.
As expected the aileron input is always on and set too 100% in both directions, with
differential being set in the aileron differential mixer
Here is an example of setting up the supplied aileron mixer template,
here are the settings in the mixer menu (GHI3)
To Next Page
Loading...
