MUNBYN IPDA018 - Scanner App Advanced Settings; Terminator and Symbology Configuration

Scanner App
Additional content
You can change the default terminator in this settings, CR and Tab
*If you want to make the Symbology config such as barcode type
enable/disable and check digit setting, you can kindly download the
honeywell documents via the link below to set the decoding.
Link for 1D version: http://bit.ly/honeywell-N431X-doc
Link for 2D version: http://bit.ly/honeywell-N36XX-doc
*Please ONLY refer and scan the codes in chapter 6, to set the decoding,
other settings might causes abnormal scanning