Munro L60iF - Diagnostic Mode; Accessing Diagnostics Mode

L60iF Issue 9 November 2018 16
8 Diagnostic Mode
Diagnostic information is provided in the L60iF for several purposes:
1. To assist in verification of correct calibration.
2. To provide statistical data of the 'hours run' type.
3. To assist in fault finding.
8.1 Accessing Diagnostics Mode
With the L60iF powered down, press and hold the (n
n
) and (
m
) buttons while powering p. An opening screen
reading L60iF Diagnostics and the version number is briefly displayed, changing to
Note that all times, dates and other numerical data in this Appendix are typical. It is always possible to revert
to a previous screen using the (
n
) key.
Press (
p
) to display
This is a dynamic display; seconds should be incrementing in real time.
Press (
p
) to display
Press (
p
) to display
Press (
p
) to display
First powered at
13:59 Mon 15/02/1999
Total time powered
00031 hrs 31 m 36 s
Pump has run for
00011 hrs 24 m 15 s
Last calibrated at
10:34 Mon 19/02/1999
Breakpoint 1
0.0 l/min ADC 0003.3