Munro L60iF - Page 20

L60iF Issue 9 November 2018 18
Press (p
p
) to display
Press (
o
) to run the pump.
The following values are displayed, updated every second. This means that the calculation of flow from ADC
and temperature values can be checked. By restricting the flow to one of the set points the corresponding
ADC value should be indicated.
An indicated flow rate of 00.0 l/min indicates an invalid calibration.
Press (
n
) or (
p
) to stop the pump.
Calibration check
Start pump oo
Temperature 40.2 C
63.1 l/min ADC 254.0