Murideo Prisma - CalMAN Calibration Results

Page
11
of
30
Call the AVPro Team at –North America 877-886-5112 International +1-605-274-6055
10) You are basically done now unless you want to create more LUTs for different modes/presets
or if you want to, run a post calibration saturation sweep to graph the result.
Note: If you are going to run a post LUT report - saturation sweeps - make sure to go back to the
Generator Tab and UN-CHECK the bypass LUT box. This will tell CalMAN to use the LUT that is
currently selected in the Prisma.
Results
Below you will find three screenshots – Before – Lightening LUT – and 2000 Read LUT. The results
are quite simply stunning!
Setup
Panasonic Plasma circa 2013 VT60 – calibrated grayscale – gamma 2.2 – CMS untouched. Black,
White, Color set correctly.
Source – DirecTV HD Genie – via Xbox 1
Processor – Murideo Prisma
STB Xbox PrismaPanasonic VT60
↑
Before LUT – been watching this TV in my home office for a few years and thought the picture
was pretty good. As you can see DeltaE 2000 is approaching 10 across the board.