Need help?Do you have a question about the MUSIC HALL pa2.2 and is the answer not in the manual?
General| Input Impedance | 47k Ohms |
|---|---|
| Damping Factor | >100 |
| Outputs | 1 x RCA |
| Gain | 40dB (Phono), 30dB (Line) |
| Frequency Response | 20Hz - 20kHz (±0.5dB) |
| Power Supply | AC 120V / 230V |
| Signal to Noise Ratio | >90dB |
| Type | Stereo Integrated Amplifier |
| Inputs | 4 x RCA (Line), 1 x Phono (MM) |
Avoid exposure to water or moisture to reduce risk of fire or electric shock. Disconnect power if exposed.
Prevent foreign objects or liquids from entering the unit; disconnect power if this occurs.
Select MM or MC mode before connecting; disconnect power first. Adjust gain for ultra-low output cartridges.
Connect turntable signal leads to MM or MC input, ensuring correct channel and ground wire connection.
Connect standard line output components to the line in input for listening or digital conversion.
Connect line out (variable or fixed) to amplifier line input; volume control affects headphones and variable output.
Connect the low voltage plug to the unit before connecting the power supply to the mains.
Connect via USB out to PC or Mac for recording; drivers may download automatically.
Lists potential causes for no signal in one or both channels.
To Next Page
